This item from our G70 Transport Chains range is built for flatbed, step deck and van load securement, with size 3/8 Inches, working load limit wll 6,600 lbs and breaking strength bs 26,400 lbs. It is offered in 5 options by chain length. Current prices run from $31.99 to $64.99.
Key specifications
- Weight (Lbs): 9.90
- Size: 3/8 Inches
- Working Load Limit (WLL): 6,600 lbs
- Breaking Strength (BS): 26,400 lbs
- Color: Gold Chromate
- End Fitting: Grab Hook
- Thickness: 3/8″
Best for
- Flatbed, step deck and van load securement
- Owner-operators building a DOT-compliant kit
- Replacing worn or out-of-service tie-downs
Tip
Add up the working load limit of every tie-down: under FMCSA rules the total must be at least half the weight of the cargo.
How buying works
Global Cargo Control lists products and prices to help you compare. Use the buy button to open the product on the retailer’s website, choose your exact option, and check out there — the retailer ships and supports your order. Prices shown in US dollars were last checked on November 7, 2026; the final price may vary.
Typical uses
- Flatbed, step deck and van load securement
- Owner-operators building a DOT-compliant kit
- Replacing worn or out-of-service tie-downs
Options available
- Chain Length: 6 Feet, 12 Feet, 16 Feet, 20 Feet, 25 Feet
There are 5 option combinations, priced from $31.99 to $64.99. The full table above lists every combination and its price.
How to choose the right g70 transport chain
Choose the grade and size by the working load limit you need. Grade 70 is the transport standard; higher grades carry more for the same size. Make sure the hooks match your binders and anchor points.
Specifications explained
- Working load limit (WLL): 6,600 lbs — the maximum load the item is rated to carry in normal service. For cargo securement, the WLLs of all tie-downs on a load must add up to at least half the cargo weight (FMCSA 49 CFR 393.106).
- Breaking strength: 26,400 lbs — the force at which the item fails in testing. It is not a working rating — always plan with the WLL, which is set well below breaking strength.
- End fitting: Grab Hook — the hardware at the end of the strap or chain. Match it to your anchor points — flat hooks for flatbed rub rails, wire or snap hooks for D-rings, grab hooks for chain, E-track fittings for E-track.
- Thickness: 3/8″ — thicker material resists abrasion and cutting better but adds weight.
Before you buy
- Match chain size and grade to the binders and hooks you already use.
- Confirm the working load limit covers your share of the cargo weight.
- Measure the length needed to reach anchor points on both sides.
Safety and care
- Never knot a chain or use a chain with stretched, bent or cracked links.
- Use edge protection where chain crosses finished or sharp edges.
- Only use alloy (Grade 80/100) chain for overhead lifting.
To complete your setup, many buyers also look at ratchet chain binders, chain hooks and corner & edge protectors — see the suggestions below.
