This item from our 1″ Ratchet & Accessories range is built for flatbed, step deck and van load securement, with size 1″ x 10′, working load limit wll 500 lbs and breaking strength bs 1,500 lbs. It is offered in 2 options by size. The current price is $47.69.
Key specifications
- Weight (Lbs): 6.80
- Size: 1″ x 10′
- Working Load Limit (WLL): 500 lbs
- Breaking Strength (BS): 1,500 lbs
- End Fitting: S-Hook
- Strap Width: 1 Inch
- Strap Length: 10 Feet
- Material: Polyester
Best for
- Flatbed, step deck and van load securement
- Owner-operators building a DOT-compliant kit
- Replacing worn or out-of-service tie-downs
Tip
Add up the working load limit of every tie-down: under FMCSA rules the total must be at least half the weight of the cargo.
How buying works
Global Cargo Control lists products and prices to help you compare. Use the buy button to open the product on the retailer’s website, choose your exact option, and check out there — the retailer ships and supports your order. Prices shown in US dollars were last checked on November 7, 2026; the final price may vary.
Options available
- Size: 1″ x 10′ – Orange, 1″ x 10′ – Green
There are 2 option combinations, priced from $47.69 to $47.69. The full table above lists every combination and its price.
How to choose the right 1″ ratchet & accessorie
Match the hook to the chain size and grade, and check the throat opening fits your fittings. Grab hooks hold a chain link; slip and clevis hooks suit other hardware.
Specifications explained
- Working load limit (WLL): 500 lbs — the maximum load the item is rated to carry in normal service. For cargo securement, the WLLs of all tie-downs on a load must add up to at least half the cargo weight (FMCSA 49 CFR 393.106).
- Breaking strength: 1,500 lbs — the force at which the item fails in testing. It is not a working rating — always plan with the WLL, which is set well below breaking strength.
- End fitting: S-Hook — the hardware at the end of the strap or chain. Match it to your anchor points — flat hooks for flatbed rub rails, wire or snap hooks for D-rings, grab hooks for chain, E-track fittings for E-track.
- Strap width: 1 Inch — wider webbing generally carries a higher rating and spreads pressure over more of the load.
- Length: 10 Feet — make sure the strap reaches over the load and back to the anchor with enough tail to tension properly.
- Material: Polyester — Polyester webbing has low stretch, holds tension well and resists UV and moisture — the standard for tie-down and lifting straps.
Safety and care
- Do not tip-load a hook; the load should sit in the bowl.
- Use hooks with latches where the load could unhook.
- Replace hooks with a widened throat or twisting.
To complete your setup, many buyers also look at g70 transport chains, shackles and ratchet chain binders — see the suggestions below.
